The cement color tile machine production line is composed of main machine, steel mold, hydraulic, pneumatic, quantitative mixing equipment, forced mixer, bucket elevator, paint and drying equipment, etc.
Main engine (1) oil tank: (2) station; (3) fast cylinder; (4) main cylinder; (5) top dead lift scaffolding; (6) frame cylinder; (7) support plate; (8) lifting bracket Cylinder; (9) Cooler; (10) Lower mold worksheet; (11) Quantitative mixer; (12) Provale cup; (13) Electric control cabinet; Main engine matching hydraulic and pneumatic control valves, including gate type Frame structure, column main cylinder piston, quick lift cylinder, cancel in cylinder, lower mold work table, swing cylinder, connecting rod and connecting equipment, its automatic production method is controlled by PLC program controller. 1 . Steel mold: Refers to the second diagram. The mold steel composition is dead, the dead pins are connected, and the die plates are connected, low dead, low dead pin connections and the frame, etc. The frame has a wear-resistant lining to adjust the gap to die on, improving durability. Note 1: Explain the adjustment to clear the mold frame. Loosen the screw inside the mold, relax the "four" tough inside, and lay the copper sheet with an inner liner of 0.05-0.5 mm thick, and then tighten it. The laying of "thickness" copper meters shall be subject to "size removal". During assembly, the mold must be clean and free of cement mortar and impurities. The mold between the frame and the mold core should be cleared after laying the copper balance sheet to prevent the mold from being clamped. In addition, a balance of force should be applied while tightening the screws around the mold, not too fast or too tight, because the liner is very stiff. The above steps should be performed to clean the colored tiles between the frames that are in the mass production process, and thus affect the quality of the colored tiles. Note 2: Repair mold 302 electrode (remove cover and weld and core electrode) or (stainless steel electrode). The location of the heat damage to 80 ℃. Argon welding machine for welding (by professional welder). After welding, grind the level after cooling, and polish and polish the slices, and then grind the oil stone. 2 . Quantitative mixer: The number of hemp machines is a vertical forced mixer. It is mixed with the provale of the World Cup and maintains sufficient nutritious meals. The height of the provale cup can be adjusted and the actual food intake each time (each brick) should be changed according to the given parameters and actual production experience. Extend and retreat the cylinder controlled by the feeding cup.
