Feb 16, 2022 Leave a message

What are the ways to deal with the sudden failure of the cement color tile machine

What are the ways to deal with the sudden failure of the cement color tile machine

 

1. Powdering

 

Construction in low temperature and high humidity environment, poor film formation of color tile paint; excessive dilution, the coating is too thin; the surface of the base layer is too loose; the base layer absorbs water too fast, no primer is used; the base layer is too alkaline.

 

Apply according to construction requirements; Follow construction specifications, do not over-dilute; Use sealer primer; Remove chalked parts, prime and recoat.

 

2. Foaming, peeling

 

During the maintenance of the tile embryo, the surface is dusty; the moisture of the base layer is too high, and its pressure will bulge the paint film when it spreads outward; all blistering and peeling parts are removed; Ensure that the moisture content of the base layer meets the construction requirements.

 

3. Pantothenic acid

 The moisture, alkali or salt content of the cement tile machine base is too high, and the water vapor will bring the salt and alkali out and precipitate on the bottom or surface of the paint film; bubble. Remove all affected paint films that have lost their adhesion. After the tile body is fully dry, treat it with oxalic acid and wash it with water, and then paint it after drying. Follow the construction specifications, do a good job of waterproofing the base layer, and ensure that the base conditions meet the construction requirements.

 

4. Uneven gloss

 

The looseness of the base layer is not uniform, and the adsorption to the paint film is not high; the thickness of the paint film is not uniform; the same side uses different construction tools; the same side uses different batches of products. Use primer, especially for local repairs; Make sure the thickness of each layer is consistent; Make sure to use consistent tools and products of the same batch, Make sure that the construction conditions and construction techniques meet the requirements.

 

5. Cracking The paint film is too thick, causing cracks; the base layer is too loose or rough. Remove all affected paint film; Make sure the paint film is not too thick in one application; Make sure the previous paint film is dry before recoating; Make sure the minimum film forming temperature of the paint film, below this temperature should not be applied.

 

6. Discoloration and fading The humidity in the substrate is too high, and the water-soluble salt crystals are weathered on the surface; The substrate contains alkali, which damages the weakly alkaline pigment or paint film; The climate of the cement tile machine is harsh; Wipe or shovel the surface and allow the cement to air dry completely; apply a coat of all-purpose alkali-resistant paint.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry