Customers who often use cement tile machines need to know the service life of the tile machine and how to protect the cement tile machine. The factors that affect the service life of the cement tile machine are as follows.
1. The power and speed of the hydraulic and pneumatic device of the cement tile machine.
In the technical parameters of the cement tile machine, the power and speed of the rotor are related to the degree of impact hardening of the hydraulic rod, which in turn affects the service life of the hydraulic system. Therefore, we set the technical parameters to a certain range, and there should be no excessive or too small situations, which will affect the service life of the cement tile machine.
2. The small internal gap of the cement tile machine.
The gap between each hydraulic roller and the hydraulic rod should be kept evenly and consistently stacked, and should not be too close or too far. The small pressure on one end will lead to uneven quality of the products produced, so this is also what we need to pay attention to. In the production of cement tile machines, molded cement tile machines and other machinery, the above are often the case.
3. The material and quality of the hydraulic system.
The material structure of the hydraulic shaft of the hydraulic system affects the mechanical properties after heat treatment. Making reasonable and scientific casting and heat treatment processes is an effective way to solve the problem of hydraulic shafts being prone to breakage during use. After heat treatment, the raw materials will be increased, and the overall tightness and pressure resistance of the raw materials will be increased, so that deformation and breakage will not occur during long-term use.
4. Material speed reading and hardness.
The blockiness and hardness of the material are proportional to the requirements for the cement tile machine material. Using suitable hydraulic rods for materials with different physical properties will help extend its service life. There will definitely be such and such problems in our production and manufacturing. Don't panic when encountering problems, but make calm judgments. In the early stage of manufacturing, we should check and try to reduce the adverse factors that may occur to a certain extent, so that it can bring results in the later use.
